Abocom UFM560 Manuel d'utilisateur

USB Series 56K V.90 Fax/Modem Quick Installation Guide M73-APO08-100

6. Click Finish. Then the installation will be fully completed. Installation for Windows ME 1. Once the 56K V. 90 Fax/Modem is well connected to

3. Click Specify a Location when you see the following picture. You may click the Browse button to select the drive:\A:\WINME folder in your disk dr

6. Select Specify the location of the driver (Advanced). Click Next. 7. Click Specify a Location when you see the following picture. You may click

8. Click Next to continue. 9. Click Finish. Then the installation will be fully completed. - 12 -

Installation for Windows XP Once the 56K V. 90 Fax/Modem is well connected to your computer as described in the previous section, you may update the

3. Select Install from a list of specific location (Advanced). Click Next to continue. 4. Select Don't search. I will choose the driver to in

5. Highlight D-Link DSB-560 USB V. 90 56K Fax Modem, and click Have Disk. 6. Load the floppy disk or compact disc whichever contains the device d

7. Click Next. 8. Click Continue Anyway when the following window appears. - 16 -

9. Click Finish to complete the software installation. 10. To verify if the device is enabled in your system, make sure the device name is modified

- 18 -

INTRODUCTION The USB V.90 56K Fax/Modem is a communication device that is Bell, ITU-T (formerly CCITT) and Hayes AT commands compatible, allowing it

HARDWARE INSTALLATION Parts Names and Functions  USB connection cable: connects the USB host port with the USB V.90 FAX/MODEM.  USB-B: USB devic

host port, push evenly and steadily until it is seated. 2. Connect another end of the USB connection cable to the device port (USB B) of your USB

3. Click Specify a location and type the floppy disk drive letter followed by driver\win 98. Click Next. Or you may click the Browse button to s

7. Select Search for the best driver for your device (Recommended) to make Windows search for the best driver for the new device. Click Next. 8.

9. Click Next to continue. 10. Click Finish. Then the installation will be successfully completed. Installation for Windows 2000 1. Once the 5

2. Click Next and put disk for the device driver into your disk drive. 3. Select Specify a Location when you see the following picture. Type the

4. Click Next. 5. Click Yes to continue the installation. - 8 -