Abocom FE1500 Manuel d'utilisateur

10/100Mbps Dual Speeds Fast Ethernet PC Card Network Adapter Installation Guide

4. Reboot your computer to activate the new device. Installation for Windows 2000 1. Insert the PC Card into the slot. When the Found New Hardwar

3. Windows will prompt a Found New Hardware Wizard dialog box. In this time, select Floppy disk drives and insert the driver diskette. Press Next.

4. Wait for a while until Windows has found the appropriate driver. 5. Click Yes to continue. 6. Click Finish. The PC Card driver installation i

7. For the first time installation, click Network icon in Control Panel to add Protocols, Client and Service if needed. 8. Reboot your computer to

2. Windows will start searching for the appropriate driver for this hardware. Select any drivers named as PCMCIA Fast Ethernet Card, and click Next

When the screen appears as below, click Continue Anyway to proceed. 4. Wait while Windows copies the appropriate driver to your system. 5. Click Fin

- 14 - Installation for Windows NT 4.0 This section describes the installation for Windows NT under the condition that Windows NT is already installed

- 15 - 8. When the Network window reappears, click on the Bindings tab. Choose your bindings. Click on the Protocols tab and select your settings.

FCC REGULATORY STATEMENTS Part15, Class B This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: 1. T

HARDWARE INSTALLATION 1. Locate the PCMCIA slot of your system. 2. Align the PCMCIA Fast Ethernet PC Card toward the PCMCIA slot. Push evenly and ste

LED Indicators  Act: Glows green when it is on, blinks when transmitting data.  10/100: Glows orange at 100Mbps, dims at 10Mbps.  Link: Glows g

- 3 - SOFTWARE INSTALLATION Installation for Windows 95 The installation procedures for the network driver may vary slightly depending on the version

2. Insert the device driver diskette into your floppy drive. When Windows prompts you What do you want Windows to do? Select Search for the best dri

- 5 - 4. The installation program will proceed automatically. 5. In the following dialog box, direct your system to copy the requested files from

6. If you are asked to insert Windows 98 CD-ROM in the selective drive, please do so to have Windows copy all the necessary files to your system. . W

2. Insert the device driver disk into the floppy disk drive on your system. 3. Windows will copy the appropriate driver to your system. If Windo